This approach is included, as a normative annex, in the Harmonized Standard EN 13445, and therefore conformity of a design to the requirements of this approach as specified in the standard implies presumption of conformity to the relevant essential safety requirements of Annex I of the Pressure Equipment Directive.
Harry Hurt III of the Texas Monthly said that the density of the apartments and the conformity of the design made it easy for criminals to operate in the complexes; if a criminal figured out how to break into one unit, he could break into all of them as they all shared the same design.
As a consequence, future biomarker studies should adhere to minimal prerequisites for conformity of study designs, case/control definitions, analytical settings, and data evaluation to ensure comparability of results.
Proximal and, to a lesser degree, distal interface contact area footprints decreased significantly with increasing flexion angle based on the conformity of the designs, resulting in a corresponding increase in the mean and peak stresses.
Under standard laboratory test conditions, it remains unclear whether conformity of knee designs results in an increased or decreased wear behavior [ 16– 16].
A subset of 400,151 SNPs was chosen for inclusion on the array based primarily on uniformity of SNP coverage across the genome and conformity with design parameters of Affymetrix.
These predictions are necessary to access the conformity of the can design to the European Packaging Standard.
The present study evaluated the effects of extent of conformity of post-cam design on contact area and stress at post-cam mechanism using 4 different posterior-stabilized prostheses.
Remarkably, IPA results are in conformity with the design of this experiment, which inferred that LA and AA acids metabolism were altered between the groups of sequenced individuals.
This conclusion is in conformity with the design principle of solar collectors for worst case conditions.
After determining the measurement coordinate system, the dimensional errors in the inspected components are estimated to verify the conformity of manufactured components to the design and tolerance specifications.
