Sentence examples for configurations for which from inspiring English sources
The proposed frequency-domain solver is applicable to rotor configurations for which sound pressure levels of discrete tones are much higher than those of broadband noise.
A gas jet in liquid crossflow represents one of the possible configurations for which there are fewer published studies than for other types of JiCF.
This paper addresses more realistic configurations for which the solute-induced density contrasts within the fluid play an important role on solute transport, in particular at small and moderate times.
The present investigation also identified the configurations for which the analytical model of the device (operating in the MILD regime), developed previously, yields reasonable accuracy for the thermal efficiency of the device, notably for the case of long cavities (L/D > 5).
A fully-coupled combustion code, 2-D, unsteady, is used to examine the behavior for highly fuel-lean configurations for which the binder slice is thin, and the diffusion flame supported by binder gases and AP decomposition flame products generates but a small fraction of the gas-phase heat output.
For a given number of MS per cell,, outage probability,, is the proportion of configurations, for which the needed BS output power exceeds the maximum output power:.
A configuration for which no other configuration exists that has both higher reward and lower risk is said to be Pareto-optimal.
It is this topological configuration for which he could first prove that a corresponding polyhedral object with 12 vertices, 66 straight edges, and 44 plane triangles could not be constructed without self-intersections.
Validation of its use for limit cycle prediction was performed for a well-documented experimental configuration, for which both experimental FDF data and limit cycle data were available.
A wire-wrapped fuel bundle is a complex configuration for which little data is available for verification and validation of new simulation tools.
The load-displacement responses were measured and compared to those of the same joint configuration for which a brittle epoxy adhesive was used.
