Sentence examples for configuration of the solid from inspiring English sources

Despite the timing of scanning, being familiar with the typical appearance of the peritoneal reflections and of the normal configuration of the solid organ could improve recognition of the intra-peritoneal blood clot, too [17].

The solid-surface approach has variants, related to the presence of the ceiling (a plane of symmetry), which can increase this error further; there is little consensus on the exact configuration of the solid surfaces in the Ffowcs-Williams/Hawkings calculation procedure.

For the three-column configuration, it is assumed that these solids leave at the bottoms of columns 1 and 2. The design and configuration of the solid-liquid separation is based on the given literature [5],[7], and the assumed insoluble solids present in the stillage are listed in Table 1 with the type denotation 'Solid'.

Reproduction of the configuration of solid obstacles in the fine mesh discretization is a direct way to make numerical calculations on porous objects.

Further, the tandem configuration of flexible solid state ion gel based PEDOT MSCs is employed to demonstrate it as a power source for glowing a red light emitting diode.

The copper macrocycle unit adopts a trans-II configuration in the solid state.

Tumor spheroids are aggregates of cancer cells that preserve native 3D cell-cell contact, mimicking the configuration of solid tumors (Weiswald et al. 2015).

As can be seen from Fig. 6a, the core radius is quite large at given operational conditions (configuration of the riser reactor, superficial velocity, and solid flux).

It is found that the configuration of the e-beam evaporator is very important for the solid carbon evaporation.

The paper presents kinematically admissible velocity fields for closed-die forging of the crown gear form which take into account the profiled teeth chosen kinematically by approximating these as trapezoidal teeth and then simulates using the velocity fields to obtain upper bound to the load and the deformed configurations of the various shaped solid billets or preforms.

In the process configurations including pellet production (scenarios B and C, see below), drying of the solid residue is integrated with the ethanol process.