Sentence examples for configuration of feed from inspiring English sources

Under the conservation law, the freedom control for an invariable surface roughness can be fulfilled in response to a quantitative ratio of hDmax/rn, either through an accurate configuration of feed rate and depth of cut with fixed tool nose radius and cutting edge radius, or by a reasonable selection of tool nose radius and controlled cutting edge radius with designed feed rate and depth of cut.

The catalytic membrane reactor was used in three different configurations of feed supply and product withdrawal.

The influence of different configurations of feed water preheating on energy consumption of MED-TVC process is investigated as well.

The configuration of the feeding apparatus differs between the investigated long-tongued and short-tongued metalmarks regarding proboscis features and the size and composition of the haemolymph pump and suction pump.

Despite the shift in the application of SWM modules of RO toward low salinity sources and the resulting higher sensitivity performance using these waters, the configuration and orientation of feed spacers have not significantly changed since the original design.

The up-pumping configuration is robust, with little effect of feed configuration or variations in geometry in the bottom of the tank on the selectivity.

The analysis of the operation of the 900-MW unit with various configurations of the feed pump drive was carried out for three load levels: for the nominal mass flow of live steam and for the partial mass flow of 75%and50%0%.

Therefore, in the fed-batch experiment of Configuration D feeding of FWM was fed starting after 24 hours allowing the yeast to adapt to the inhibitory environment.

The configuration of the air-feed system was changed by means of valves at two locations in the system.

In this study, four types of feed spacer configurations are investigated, with a total of 20 geometric variations based on commercially available spacers and selected filament angles.

In the separation processes, the influence of operating parameters including reflux ratio, mole fraction of HCl in the feed stream, solvent flow rate and temperature, and column configuration variables such as the location of feed stage and number of stages on the heat duty requirements and the composition of products are investigated and analysed.