Sentence examples for conducted an optimization from inspiring English sources

We conducted an optimization using the second-order response surface method to determine the transverse rib geometry required to achieve the highest cooling performance in a circular channel.

Aslan et al. (2007) conducted an optimization study by machining a hardened AISI 4140 grade (63 HRC) steel with Al2O3 + TiCN mixed ceramic inserts in order to analyze the effect of cutting parameters (cutting speed, feed rate and depth of cut) on surface roughness and flank wear by employing Taguchi technique, ANOVA and regression analysis.

We thus considered R and the first two moduli m1 and m2 as parameters (with the values produced by the Emri-Tschoegl algorithm as initial guesses for the mi), and conducted an optimization search to find the values that would yield (through Eqs. 11, 12, 5, and 13) the best possible fit to the peri-elongation data.

We conduct an optimization based on an impulse response representation of the system's dynamics for a chosen control horizon.

A new method based on entransy dissipation analysis is applied to conduct an optimization design to the ATT.

We conduct an optimization search for this tradeoff for the cases of sixteen, eight and four users per BS scheduler, and the results are as summarized in Figures 4 and 5.

It may not be rational to conduct an optimization without ensuring adequate precision of the optimum.

As variability is likely to exist in primary endothelial cell isolation yields and model set up, it may be beneficial to conduct an optimization study, such as the one presented here, prior to applying the model.

Recognizing that the requirements were four years old and set with limited sector information, the MOHSW HR Unit, with Clinton Health Access Initiative (CHAI) support, conducted a workforce optimization study to review minimum staffing requirements and calculate optimal workforce needs.

The analysis of Taguchi method conducted with an optimization process to reach minimum pressure drop (friction factor) and maximum heat transfer (Nusselt number) for the designed heat exchanger.

Robustness is needed to account for architecture and algebraic singularities that are likely to occur, for example, when conducting an iterative optimization of the linkage at hand.