Sentence examples for conditioning pulses from inspiring English sources

Long (1 s), but not short (60 or 100 ms), inactivating conditioning pulses (CPs) suppressed the 5HT-induced increase in INa.

We illustrated the results of prolonged conditioning pulses to ensure steady state was reached for the pharmacological experiments that follow, but similar results were obtained using conditioning pulses of 500 ms (data not shown).

The I/Imax was determined with the protocol as shown in the left inset (with 1-s conditioning pulses from voltages between −120 and −10 mV then to a 50-ms test pulse to 0 mV).

The I/Imax was determined with the protocol as shown in the left inset (with 1-s conditioning pulses from voltages between −100 and −10 mV followed by a 300-ms test pulse to +60 mV).

We measured availability curves for both WT and mutant channels using conditioning pulses of 0.5 s (not illustrated) and 5 s (Figure 4A) using voltages that ranged from −120 mV to −20 mV.

Conditioning pulses lower than −90 mV have little effect on the subsequent peak current.

These are gas conditioning, pulse energisation, ESP-fabric filter (FF) combination, improved horizontal flow as well as open top ESP.

Thus changes in the effectiveness of the conditioning pulse give an indication of how the excitability of the connection changes over time and during a specific task.

Both peak P2 currents and dV/dt amplitudes were normalized to their maximum values and plotted versus the conditioning pulse (P1) voltage.

The steady-state inactivation of the total current was measured using a 150 ms conditioning pulse to voltages between −90 and 0 mV with 10 mV increments.

Cells were current clamped and a 200 msec, −20 pA conditioning pulse followed by a 1 sec 20 pA step was used for stimulation.