Maximum temperature reduction of 25.91% was reported at condition of vs = 15 m/s, vw = 500 mm/min, ae = 0.4 mm in the presence of ultrasonic vibration.
Of the 114 medical articles, 61 (6.3% of 967) described the condition of VS, whereas 53 discussed other medical problems such as the pathophysiology of death by dehydration; the technical requirements for, and the goals and the complications of the artificial nutrition; head trauma as a major cause of the VS; the definition and diagnosis of brain death (Table 2).
The dislocation density will be increased obviously and the maximum is acquired on the condition of V = 10 °C/min, T = 24 h and N = 1.
We observed no significant change in the condition of V males in terms of body mass, furcular fat score or food intake rates, although locomotor activity declined slightly after implantation.
The drain current of an OTFT was continuously monitored under the bias condition of V DS = −30 V and V GS = −30 V.
Open image in new window Fig. 11 a Endurance measurement of as-fabricated NFGM under the condition of V d = −5 V and Vg = 0 V.
Open image in new window Fig. 6 a−c Photocurrent (I ph) of monolayer, bilayer and multilayer MoS2 FETs measured in air (under the condition of V ds = 0.5, 2.0, 5.0 V and V G = 0), respectively.
The efficiency of the proposed converter under the condition of V i =10 V, duty ratio D=0.2~0.4, R L =100 Ω was measured, and a comparison between the measured and the theoretical predicted efficiencies is presented in Fig. 12.
In Fig. 6, photocurrent (I ph) of monolayer, bilayer, and multilayer MoS2 FETs was measured in air (under the condition of V ds = 0.5, 2.0, 5.0 V and VG = 0) and illustrated in Fig. 6a c, respectively.
The as-fabricated memory device exhibits multilevel non-volatile memory nature, as illustrated in Fig. 11. Figure 11a depicts the endurance of this NFGM, which is more than 102 times (under the condition of V d = −5 V and V g = 0 V).
In the case of E + I − 2 E I ≥ 0, the monotonicity of δ ( g ) suggests that for a trajectory evolving from an initial condition of ( v, g ) = ( 0, g ( 0 ) ) to a final condition ( v, g ) = ( 1, g ( t ) ), the drop g ( 0 ) − g ( t ) should be smaller for larger g ( 0 ).
