Sentence examples for condition calibrated from inspiring English sources

These meta-analyses typically report effect sizes (signified by d), which refer to the difference between the ITS condition and a control condition, calibrated in standard deviation units.

These conflicting demands require a continual process of monitoring uncertain conditions, calibrating investment in safety in relation to cost of failure, and adapting to changing operating conditions in near-real time.

The objectives of this paper are to characterise the lateral root distribution of poplar trees using datasets from two different locations in order to compare the influence of environmental conditions, calibrate the root distribution model from Schwarz et al. (2010a), and calculate the spatial distribution of root reinforcement on slopes with different tree spacing.

To further improve the efficiency of RCS, a parallel evaporative cooling system (cooling tower) is coupled with RCS and analyzed for different climatic condition using calibrated model.

The permanent deformation model modified for the geocell reinforced condition is calibrated using numerical analysis and the model can be used to predict the deformations for higher number of load cycles.

H C cross-polarization conditions were calibrated using C-enriched glycine, and the CP condition was met by using a ramped (∼15%) H spin-lock pulse centered at 130 kHz RF field strength, and a square spin-lock pulse on the C channel matched to the −1 spinning side bands of the Hartmann–Hahn profile.

Empirical correction factors are introduced into the boundary conditions and calibrated against direct simulation Monte Carlo data.

All of the spectra were obtained under identical conditions and calibrated against a value of the C 1s binding energy of 284.5 eV [29].

The speed and density distribution of microscopic parameters about freeway traffic flow under different rains was researched, and the highway two-regime speed density distribution traffic flow model under different rainfall weather conditions was calibrated.

Corresponding analysis and non-destructive prediction of the ruggedness of power DMOSFETs devices supported by advanced 2-D mixed mode electro-thermal device and circuit simulation under UIS conditions using calibrated physical models is provided also.

The major fraction showing antibacterial activity was re-chromatographed in the same column under similar conditions, but solvent B was used as 100% ACN with a gradient of 0-10% for 30 min. Peptide concentration was determined using the RP-HPLC conditions and calibrated with surfactin (Sigma-Aldrich).