Sentence examples for concentrations of the solution from inspiring English sources
It was found that calculated results agree fairly well with experimental data for a wide range of operating conditions of gas and liquid flow rates, gas phase composition, H2O2 and H2SO4 concentrations of the solution.
Their occurrence implies elevated Si concentrations of the solution after reaction and may be related to the observed dissolution of quartz during the experiment (Fig. 18).
At least six concentrations of the solution were analyzed in duplicates, and then the calibration curves were constructed by plotting the peak area versus the amount (ng) of each analyte.
At least seven concentrations of the solution were analyzed in two replicates, and the calibration curves were constructed by plotting the peak area ratio of individual standard to IS versus the concentration of each analyte.
In the equation, Q (in mg g−1) is the amount of DOX · HCl adsorbed; C 0 and C (in mg mL−1) are the concentrations of the solution containing of DOX before and after adsorption, respectively; V (in mL) is the volume of the solution; and m (in g) is the amount of ACPs.
Radcliffe et al. (2004) found E. faecalis to be the most resistant strain to sodium hypochlorite and found that lower concentrations of the solution required longer contact times with the microorganisms; a 0.5%% solution of NaOCl required 30 min of contact to totally eradicate E. faecalis whereas a concentration of 5.25 % NaOCl only required 2 min of contact time.
The concentrations of the solutions were varied from 0.21 × 10−2 to 35 × 10−2 mol/L PdCl2.
A reciprocal dilution experiment was performed to determine the extent to which on-slide concentrations of an oligonucleotide were mimics of the effects of variable concentrations of the solution-phase cRNA partner in bi-molecular hybridization reactions and therefore suitable for normalizing experimental variations in cRNA hybridization.
The concentrations of the solutions of capsaicin were measured by high performance liquid chromatography (HPLC).
The Zn concentrations of the solutions were determined by reverse isotope dilution mass spectrometry to plan the preparation of the final DS solution.
