Sentence examples for concentration degradation from inspiring English sources

The absorption spectrum of the supernatant solution was measured on a Perkin Elmer Lambda 950 UV/vis spectrometer (Waltham, MA, USA), and the concentration (degradation) of methyl orange was determined monitoring the changes in the absorbance at 465 nm.

Field tests and modeling studies indicate that, at high TCE concentration, degradation becomes stoichiometrically limited.

Given that the assay is dependent on antioxidant concentration, degradation media at 24 h were analyzed and compared to freshly prepared solutions of free bioactives of the same concentrations (52 μg/mL for carvacrol, 74 μg/mL for eugenol, and 100 μg/mL for thymol).

At higher initial DMP concentrations degradation also occurred, but at a slower decay rate compared to lower initial concentrations.

Increasing the graphene concentration up to 1 wt% did not change the rate of degradation but at higher concentrations degradation was slowed.

The rate constant values (k obs') for the set of kinetics performed for lindane (5, 7.5 and 10 ppm initial concentrations) degradation were calculated to be 0.057, 0.035 and 0.034 min−1, respectively.

Possible false-negative analyses could result from multiple confirmation ions that limit the sensitivity of detecting low concentrations, degradation of AM in the samples that had undergone several thaw-refreeze cycles, or inadvertent dilution of AM during the pooling process.

This result strongly supports that high cellular heme concentration impairs degradation of Sqstm1 by the homeostatic protein degradation pathways.

Degradation and synthesis of glycogen are regulated in opposing ways, with phosphorylation and increased AMP concentration activating degradation and at the same time inhibiting synthesis [ 9].

Figure 10 Changes of MB concentration photocatalytic degradation in the presence of samples.

It has been observed that with increasing particle concentration, the degradation in boiling performance takes place which increases the heating surface temperature.