Sentence examples for concentration approximation from inspiring English sources

In this model, a predictor-corrector strategy is used for updating two internal states, especially used for solving the electrolyte concentration approximation to reduce the computational complexity and reserve a high accuracy of the approximation.

The quasi-stationarity equations become linear after applying the strong binding, large concentration approximation for the transcription factors FTAx-y-z.

Kinetic studies in a well-mixed batch reactor provide kinetics parameters and an activation energy of 71 kJ mol−1 but cannot discriminate between a first order or a complex kinetic model within the range of substrate concentration where the approximation of linear liquid/liquid partition is respected.

We derived the local epidermal concentration using an approximation based on the known diffusion coefficient of a small cationic protein in aqueous solution (see supplemental materials for assumptions and dimensions of the system, used for modelling).

Then, the product of the protein pairs in terms of concentration is the approximation for the activity of protein-protein interaction in the cell, which is a similar measure as the correlation based measure.

When the Michaelis constant was 0.33, well within the range of the substrate concentration, the simplifying approximation was never supported by the data until high amount of noise in the data (See Table  3).

Assuming that the complex concentration is approximately constant after a short transient phase leads to the usual Michaelis Menten (MM) approximation (or standard quasi-steady-state approximation (sQSSA)), which is valid when the enzyme concentration is sufficiently small.

Therefore, for the estimation of the short calibration interval (three consecutive concentrations), the linear approximation is sufficient.

The initial time profile of the surface bound protein concentration under these approximations is given by 6where [ PG ]0 is the bound monovalent HA protein glycan receptor complex at the time of washing buffer injection (t′ = 0).

From the extended LDF approximation, intraparticle concentration profiles during a cyclic process can be calculated and an insight can be gained on the dynamic changes during the process.

Calculated separations for distillation trays, over a wide range of operating conditions, suggest that the proposed model provides a better approximation of concentration profiles, compared with the multicomponent efficiency (MEF) and the NEQ stage model.