Sentence examples for compressing forces from inspiring English sources

Assuming that the compressing forces are physically realizable ergodic processes the plate dynamics is described by stochastic classical partial differential equations.

They showed that the compressing forces were very low when sitting on a Bobath ball, which indicates that this position would probably not cause pain.

Kavcic et al. [ 29] showed that the compressing forces on the segment L4 L5 as well as the forces of the stabilization muscles were greater when the unilateral pelvic lift was performed compared with sitting on a Bobath ball.

Kavcic et al. [ 29] examined different positions traditionally used in stability training of the lumbar spine, and related these to the compressing forces on segment L4 L5 and the muscular stabilization effect.

As discussed in our previous studies [ 7, 8], in order to standardize the raw data set acquirement process, the compressing force was exerted until a maximal compression of its anterior portion was obtained and the cervical lip begins to be dislocated without further compression.

The critical damping coefficient has been expressed by the variance and the mean value of compressing force.

The friction force or torque plays an important role in limiting lateral deflection, especially when the car bears a large compressing force.

Kant then specifies several central features of repulsive forces in Propositions 2 and 3. Repulsive forces admit of degrees to infinity, since one must always be able to think of a slightly greater or lesser force, and although matter can be compressed to infinity, it can never be penetrated, since that would require an infinite compressing force, which is impossible.

To help clarify the significance of this, Fazang made metaphorical use of a traditional, timber-framed building that is held together without any fasteners by the compressing force of gravity on all of its parts (Huayan wujiao zhang, in Taishō shinshō daizūkyu, Vol. 45, no. 1866).

The measurement of the stiffness in very short cervices can be limited, due to the impossibility to direct the compressing force perpendicularly to the cervical tissue.

With less steel raw material required for building, vertical balers are more cost effective compared with horizontal balers of similar compressing force.