Sentence examples for composition by weight from inspiring English sources
Analysis of the surface composition of these films using XPS indicated that the surfaces of the blend films were completely covered by PTEVS after 10% composition by weight.
Table 1 Typical percentage composition by weight of naphtha cracking products Component Wt% Composition Hydrogen 1 Benzene 6 Methane 16 Toluene 3 Ethene 32 Aromatics 2 Propene 16 Fuel oil 4 C4 hydrocarbons 8 Others 12.
Equivalently, a cylinder provided with a 1-mm thick PMMA lateral wall (ρ = 1.19 g cm−3) was implemented in MCNP simulations (elemental composition by weight: H = 0.080538, C = 0.599848, and O = 0.319614).
In the first phase, six levels of the LDPE powder (5 30 wt.%) based on the composition by weight, were mixed with the core particles with 8 wt.% urea formaldehyde (UF) resin.
Thermoplastic polysulfone (PSF) was melt blended with a novel oligomer poly bisphenol-A) (m-Bpoly bisphenol-Aamples of varying compositoon by weight producePA of 99/1, 95/5, 90/10, and 58/42.
It is well known that hydrocarbon feed stock streams, such as naphtha, LPG, or gas oil are cracked in a furnace to produce mixtures of hydrocarbons of varying molecular weight [14, 15, 16, 17, 18, 19], a typical percentage composition (by weight) is presented in Table 1.
Alloy compositions were, by weight percent, Be47.5Al2.5Ag, Be47Al3Ag, and Be46Al4Ag.
The object of investigation was the alloy of the following composition: 84.7Cu-11.4Al-3.9Mn (% by weight), smelted in an induction furnace in an argon atmosphere.
The properties of starch/styrene maleic anhydride (SMA)/ethylene propylene maleic anhydride (EPMA) were studied at a constant starch composition of 60% by weight.
The sample composition was 11%% by weight in polymer in order to reach a compromise between the minimum amount of polymer to bind the tellurium grains and the maximum concentration of tellurium to obtain suitable electrical properties for device applications.
Fluorescence non-radiative energy transfer experiments were used to study latex blend films composed of high molar mass poly(butyl acrylate-co-methyl methacrylate) (PBA-co-MMA) and much lower molar mass PBA-co-MMA latex of the same chemical composition (50 50 BA MMA by weight).
