Sentence examples for composites were placed from inspiring English sources

The obtained composites were placed in 12.5 ml of 0.25% solution of glutaraldehyde in water and heated at 50 °C for 2 h.

Multifiber composites were placed under constant load creep tests and the fiber strains were evaluated with time after one fiber break occurred.

During the thermal decomposition, the as-prepared SrTiO3/BiOI composites were placed into a tube furnace, and the heating program was set as follows: ramping at 5 °C min− 1 to 500 °C continuously and holding at 500 °C for 3 h.

The moulds filled with the composite were placed in a vacuum chamber to remove all air bubbles in the samples due to mixing.

Then the composite was placed in a sodium hydroxide solution to dissolve the template after the solvent completely evaporated.

The composite was placed in bulk mode (to increase the challenge caused by polymerization shrinkage of restorative material) and a mylar strip was placed over the cavity.

Therefore, alignment of GNPs in Larit 285 was performed by the experimental set when the composite is placed between plates of capacitor.

The conductive cement-based composite was placed over the copper-containing base concrete layer, followed by a concrete protective layer.

The entire procedure was performed via ankle arthroscopy and, after the preparation of the lesion, the biological composite was placed in the defect site through a cannula and using a probe to obtain the best possible fit.

The as-formed MIL-88B@ZIF-67 MIL-88B@ZIF-67 MIL-88B@ZIF-67amicomposited heated to 500 °C at a ramp rate of 5 °C min−1 in a tube furnace under ambient atmosphere.

A wide variety of targets, both elemental and composite, was placed in the particle beams, and the spectra of particles emerging from the targets were measured using a stack of silicon detectors.