Sentence examples for composites was only from inspiring English sources
The weight loss rate of the double-layer-coated composites was only 0.44% after oxidation for 100 min at 1773 K, while the weight loss rate of inner-layer-coated composites reached 25.35%.
These results indicated that the weight loss of the coated C/C composites was only 0.8% after oxidation in air at 1873 K for 500 h, and the sample was fractured after erosion at 1873 K for 32 h in wind tunnel.
The test results showed that the fracture toughness of the SiC coating increased from 9.1 MPa m1/2 to 19.7 MPa m1/2 after introducing the SiC nanowires (SiCNWs), and the mass loss of the coated C/C composites was only 0.48% after oxidizing at 1637 K for 420 h, whereas the mass loss of pure SiC coated samples was up to 1.48% after oxidizing at 1637 K for 16 h.
However, mechanical moduli of the annealed SWNT/PS composites are only increased slightly.
In strengthening of RC structures the utilization of externally bonded FRP composites is only up to 35% because of the pilling-off failure mechanism.
Because the Nafion®/PTFE composites are only 31 μm thick, their areal resistance is lower than that of Nafion® 112 membranes: 0.031 vs 0.036 Ω cm2.
The stress strain behavior of the composites is only slightly altered with CNT addition; however, the strain at break is decreased even at low loadings.
X-ray diffraction results reveal that the composites are only composed of BaCeO3-based and SDC phases without any other impurity phases.
No other characteristic peaks of impurity are detected, suggesting that BiPO4/Bi2S3 composites are only composed of BiPO4 and Bi2S3 phases.
The application of nanoscaled silver or nanosilver composites is only one possibility besides the use of silver salts, silver ion exchangers, silver composites and elemental silver.
However, the SF and GCG resin composites are only light-cured composites and exhibited an adhesive mode of failure; therefore, heat treatment of BG may increase the bond strengths to the Techceram substrate.
