Sentence examples for composites produced from from inspiring English sources
We demonstrate the use of simple thermal oxidation processes to purify bulk carbon composites produced from thermosets, which were formulated from precursor compositions containing a melt-processible organometallic Ni catalyst in an excess of carbon source.
The thermal conductivity of carbon/carbon composites produced from the modified carbon performs by chemical vapor infiltration was also studied.
Water absorption and thickness swelling (at 2 h and 24 h) compared favorably with values reported for cement-bonded composites produced from virgin wood particles.
A 2.4-fold increase in cyclic voltammetry current accompanied by decrease in overpotential from the composites made from the nanosized, needle-like-free ZnO shapes was observed as compared to those composites produced from needle-like shaped ZnO.
The samples prepared using 1K plain carbon cloth have a uniform microstructure, and consequently possess the highest flexural strength, while the composites produced from 3K plain carbon cloth possess the lowest value due to their poor microstructure and lower strength fibers.
No additivity of characteristics was observed for the similar composites produced from Fe and Cu powders with treatment in the planetary mill.
N-TiO2/AC (400M-700T) composite produced from two-stage calcination (400 °C in air with subsequent 700 °C in NH3/N2 atmosphere) was comprised of anatase rutile phase and this composite exhibited significant PCD efficiency for removing BPA under simulated solar irradiation, with initial pseudo first-order rate constant of ca. 0.67 h−1.
Compared with single groove, composite produced from the gradient grooves was found to have uniform distribution of the powder.
Part 2 presents the cost optimization, comparison and competitiveness between three different composite floor systems: composite beams produced from duo-symmetrical welded I sections, composite trusses formed from rolled channel sections and composite trusses made from cold formed hollow sections.
The composites were produced from industrial available MWNT by extrusion melt-mixing and injection-molding.
Glass/polyester composites were produced from continuous rovings using filament winding method.
