Sentence examples for composite remaining from inspiring English sources

The amount of composite remaining on the enamel surface was examined immediately after bracket removal.

The enamel surfaces were examined with a stereomicroscope (Stemi 2000-C, Carl Zeiss, Gottingen, Germany) under ×16 magnification to determine the amount of composite remaining, and then they were classified according to adhesive remnant index (ARI).

Microscopic examination of the surface of the alumina substrate bonded to the BG resin composite revealed that the failure occurred at the bulk of the material, with residue of the veneering composite remaining on the core.

According to the adhesive remnant index (ARI) system used in this study [ 29], the most desired clinical condition is a low ARI score with less composite remaining on the enamel surface.

The latent heat of the composite remained very close to the value of the alloy alone.

For the week, the Dow Jones industrials dropped 4.9percentt, its biggest loss since Oct. 15; the Standard & Poor's 500-stock index fell 2.6percentt; while the Nasdaq composite remained in positive territory, up 3.6percentt.

In addition, while the strength and stiffness of the composite remain largely a function of the reinforcing material that is, the fibres the matrix can contribute other properties, such as thermal and electrical conductivity and, most important, thermal stability.

After 56 days the PG in the 40Si10/0Fe10 composite was completely dissolved, whereas 67% of that in the 0Si10/40Fe10 composite remained.

The compressive strength, thermal conductivity and coefficient of thermal expansion (CTE) of the composite were found to decrease after every ablation test, whereas the specific heat capacity of the composite remained unchanged.

Especially, NF/RGO/SnS2 composite remained the specific capacity as high as 561.9 mA h g−1 at the current densities of 1000 mA g−1 after continuous tests for 160 cycles, which is much higher than conventional SnS2/RGO composite.

Measurements of crack opening profiles have shown that crack tip in the composite remained closed at fairly high stress intensities and was opened to a much smaller displacement compared to the crack tip opening in the matrix alloy at the same stress intensity.