Sentence examples for components of loading from inspiring English sources
Lumbar burst fractures typically require an axial compressive load and have been known to occur during a non-horizontal crash event that involve high vertical components of loading.
The interactions of axial force vs. the out-of-plane normal force, developed in the unit width of FRP at the failure, resulted from mode II and mode I components of loading were also derived.
Displacement chromatography incorporates an element which displaces the components of loading feed by having a higher affinity for the stationary phase which results in a zone of purified feed components that runs ahead of the displacer.
In addition the detection of harmonic components of load current, design of conventional proportional integral (PI) current controller and hardware implementation for active filters are also discussed.
The proposed control strategy has been designed based on passivity technique and provides compensation for the active, reactive, and harmonic current components of loads during the connection of DG link to the grid.
The fundamental components of load-side currents are feed-forwarded in the current control loop using two groups of synchronous frame adaptive linear neural networks (ADALINEs) to ensure a fast dynamic response.
Following the ISO 14243-1 sthedard, tibialbial construct was loaded with three components of load.
I αq and I βq are amplitudes of fundamental components of load reactive current of two power supply arms, respectively.
Decreasing implant thickness and glenohumeral conformity reduce the eccentric component of loading and may improve the durability of glenoid implants.
Experimental results confirmed that when the interface experiences mode I component of loading in the form of normal out-of-plane tensile or compressive stresses, the bond strength would respectively decrease or increase over the control specimen.
However, limping was enhanced by perturbations that increased the vertical component of load on the motor, including increases in bead size or net load, and decreases in the stalk length.
