Sentence examples for components less from inspiring English sources

He went into home building, found a way to produce certain construction components less expensively and started making them himself.

Marc Hassinger, a BMW spokesman in Munich, said that the company already had "very positive" sales in China and would hope to further benefit if an appreciation of the currency improved domestic purchasing power and made imported components less costly.

Besides, the input frequency components (less than 5 Hz) of the damped wave field should be raised appropriately to enhance the input spectrum energy.

Both series of micelles were found to be globular up to 0.7 mole fraction of DHPC, while the aggregation numbers varied within the same concentration range of the components less than 15%.

The proposed circuits are more efficient comparing to previously published ones in terms of the number of optical components (less by 50%) as well as the operational speed (faster by 50%).

It discusses microactuators that are physically smaller than 1 mm3 and made of critical components less than 1 mm in size, or that are produced with micromachining process technologies.

The forecast is also designed, however, to weight the economic component less and less as time goes on, eventually defaulting to a purely poll-based model by Election Day.

Remember, however, that we deem the GLOBAL scenario component less likely to occur, since it will be potentially restricted to specific industries.

The crystalline phases consist of crystalline domains ≈7 nm in size of Ni(W) (fcc) solid solution (12 at% W content) and a minor Ni4W component (less than 10%).

The figure at 09 20 00 UT shows that LOS velocity has a sunward component less than 200 m/s in the west part of the FOV and presents weak antisunward flow in the center of the echo band (across the polar cap).

This enables the fabrication of a microscale cylindrical component less than 100 μm in diameter with an extremely large aspect ratio, which is extremely difficult to produce by conventional machining techniques.