Sentence examples for component under test from inspiring English sources
In practise, the use of smoke tests to evaluate the impact of failure injected at the architecture level may be challenged by the existence of optimisation techniques such as caching for instance, which may prevent to properly exercise the dependency of the component under test.
In order to evaluate the dynamic behavior of proton exchange membrane (PEM) fuel cells and their auxiliaries, the dynamic capability of the test system must exceed the dynamics of the fastest component within the fuel cell or auxiliary component under test.
In this paper, the mass flow rate characteristics of high-pressure pneumatic components (HPPC) are measured by a compounding approach; two components under test with the same geometry and dimension are needed to be connected in series.
The new device was designed to excite the components under testing with pure torsional vibration mode at a frequency of 20 kHz.
In this paper, 3D FEM modeling and submodeling techniques are employed to compare the dynamic response of several 3D componentsents under drop test loading conditions.
The simulation results show that our resulting diagnostic system can classify the faulty components of analog circuits under test effectively and achieves a competitive classification performance.
The selection of suitable geometrical parameters has been identified as an important aspect regarding the proper operation and installation of the coil around the under test power component.
Previous hardware/software co-design frameworks have only considered the design-under-test (DUT) application for hardware components.
OUT can mean an electronic component, examinee, program unit or material under test, etc.
The methodology was validated with component testing under different loading conditions including constant and variable amplitude in-phase and out-of-phase axial torsion experiments.
When based on structural stress acting on shell elements, the stress simulation for welding seams on thin sheets provides no sufficient correlation with damages occurring during real component tests under operational load.
