Sentence examples for component of load from inspiring English sources
The overcurrent will only happen in shunt converter if the harmonic component of load current is very large.
To deal with unbalanced loads, this paper proposes a matching-ratio compensation algorithm (MCA) for the fundamental active component of load currents, and by employing this MCA, balanced three-phase grid currents can be realized under 100% unbalanced loads.
When D < cosφ, although UPQC-SRI could compensate the voltage sag by reactive power injection, the shunt converter will inject reactive current with the same phase as the reactive component of load current.
Aimed at the problem of control shocks existing in traditional one-cycle control, the improved control unit is given out with the fundamental positive sequence active component of load current as control objectives.
Small capacity RPC in series with output reactance L 0 and in parallel with high-pass filter HPF at the output port is installed on both ends of the traction power supply arm through step-down transformers ST1 and ST2, compensating for rapidly changing component of load.
To overcome the above shortcomings, a matching-ratio compensation algorithm (MCA) for the fundamental active component of load currents is proposed to calculate the grid current reference, so as to optimize the sine and balance degrees of the grid currents, reduce the steady-state fluctuation of the DC bus voltage, and improve the dynamic response speed of the DC bus loop.
Decreasing implant thickness and glenohumeral conformity reduce the eccentric component of loading and may improve the durability of glenoid implants.
Experimental results confirmed that when the interface experiences mode I component of loading in the form of normal out-of-plane tensile or compressive stresses, the bond strength would respectively decrease or increase over the control specimen.
Following the ISO 14243-1 sthedard, tibialbial construct was loaded with three components of load.
I αq and I βq are amplitudes of fundamental components of load reactive current of two power supply arms, respectively.
In addition the detection of harmonic components of load current, design of conventional proportional integral (PI) current controller and hardware implementation for active filters are also discussed.
