Sentence examples for compliance ratios from inspiring English sources

Open image in new window Figure 12 Compliance ratios associating with the rotational freedom Open image in new window Figure 13 Compliance ratios associating with the translation freedom.

Open image in new window Figure 16 Compliance ratios associating with the rotational freedom.

On the contrary, the compliance ratio c44/c55 rises when the distance a increases, and the compliance ratios c44/c66 is independent of the parameter a. Open image in new window Figure 14 Compliance ratios associating with the rotational freedom Open image in new window Figure 15 Compliance ratios associating with the translation freedom.

It is shown that with the increase of the angle of beam orientation, the compliance ratios c11/c22 and c44/c66 both decrease.

The compliance ratios (c11/c22, c11/c33, c44/c55, c44/c66) are plotted against the distance a in Figures 14 and 15. Figure 14 shows that as the distance of intersecting beams increases, the compliance ratios c11/c22 and c11/c33 both decrease to approximate 288.

Based on the illustrated analysis above and in view of the design purpose for this paper, (theta = {uppi mathord{/ {vphantom {uppi 4}} kern-0pt} 4}) is selected to enable all compliance ratios to be large enough for better performance, so that we can obtain relatively high compliance in the specified DOF direction and relatively low compliance in the specified DOC direction.

Therefore, the trend in compliance ratio c11/c33 towards better rotational constraint.

For example, the partial closure or adjusted compliance ratio (ACR) methods are required to obtain the best correlation of data.

For the value of compliance ratio c44/c55, almost constant larger than 50, can be referred to a translational DOF along the x-axis.

Both the classical Elber's approach and more recent approaches based on partial crack closure concept (adjusted compliance ratio, ACR, and 2/π methods) were considered.

Although this new model, as an augmentation of Newman's model, shows great promise, both of these models require measurements of opening loads which are avoided by Donald's 'adjusted compliance ratio' and other approaches.