Sentence examples for compliance correction from inspiring English sources

Also, none of the specimens showed slippage at the grips, hence no grip compliance correction was needed.

Assuming all of the discrepancy between the theoretical and actual length tension relation is due to compliance, a correction factor can be generated.

A monitor chosen by the civil liberties union will be able to inspect the prisons to ensure compliance, and the corrections department will be required to publish quarterly status reports to its website.

As questions about compliance with the corrections policy for The Times Op-Edd columnists continue to arise, Gail Collins, editor of the editorial page, told me in an e-mail Tuesday that she will "address the issue in a forthcoming letter from the editor" in the paper.

Several crack length measurement techniques including beachmarking, linear correction and compliance measurement were discussed and the results were compared.

"We find that the statements made in the allegation of compliance and evidence of correction: 1) failed to adequately address the deficient practice cited; 2) are incomplete and failed to meet the criteria of acceptable evidence of correction; 3) do not ensure sustained compliance; and 4) show a lack of the CLIA requirements".

It uses the principle of conservation of mass (power) and assumes that following correction for compliance there is a linear relationship between netpower and netflow.

Even when COPE concluded that a complaint regarding undisclosed conflict of interest was substantiated and recommended that the journal involved publish a Correction in compliance with COPE's policy, COPE categorically notified the journal that it was free to disregard COPE's recommendation and continue as a COPE member without any consequences.

While compliance is required getting corrections made can be a long term process.

The results demonstrate a significant improvement arising from the use of the CJP stress intensity factors and also highlight the fact that the CJP crack tip field model does not require the incorporation of compliance-based geometry-correction factors in the calculation of stress intensity.

For nanoindentation on bulk-like γ′-Fe4N, the correction of structural compliance was applied to remove the influence of the porosity as well as of mounting.