Three lists of differentially expressed genes were then generated by comparing each of the 'inflammatory' groups (which themselves exhibited comparable acute phase responses) with the OA group (>1.2-fold change; uncorrected p<0.05; online supplementary gene-lists 2 4).
Second, and crucially, we found similar HRV values when comparing each of the tasks with its oddball control equivalent, and a significant decrement in HRV as a function of time-on-task.
This report builds on the previous work, systematically comparing each of the three most commonly used dynamic simulation modeling methods—system dynamics, discrete-event simulation, and agent-based modeling.
Comparing each of these values with the respective ones of the BPT model, the estimates of the Poisson models are about two times larger than those of the BPT model.
Comparing each of these expressions with the DMT upper bound in (9), we see that the best relay selection method is the only one which can always achieve the DMT bound.
While comparing each of these parameters between MIS and open group, all revealed no statistical significance (VAS-back: 1.0 versus 1.2, P = 0.471, VAS-leg: 0.6 versus 0.9, P = 0.371, ODI: 12.0 versus 13.5%, P = 0.461).
Relative risk (RR and 95%% confidence intervals (CI) were calculated for each adverse patient outcome by comparing each of Quartile 2 (Quartilertile 3 (Q3) and Quartile 4 (Q4) to Quartile 1 (Q1).
When comparing each of the sixteen windowed 1-sequence numerical representations using WL = [9,15,24] bases to a non-windowed 4-sequence numerical representation (such as the Voss representation), the speed improvement ratio increases as SL increases which favours long nucleotide sequence analysis.
Comparing each of the plastic types overall, it was evident that the ductile 75:25 albumin-water and the 80 20 albumin-rubber plastics were the best types of bioplastic to use, depending on the intended use, as the water-based samples allowed large amounts of extension before breaking, while the rubber-based samples were stiff and required the highest amount of load needed to break the samples.
The sensitivity of the array was measured by comparing each of the mutant-templated arrays to those templated by unmodified, wild type nucleic acid.
Coomassie staining comparing each of these eluates revealed that, other than the bands corresponding to TEV protease or BSA bands, the eluates in all three cases revealed essentially the same set of protein bands (Figure 4A).
