Sentence examples for command of the software from inspiring English sources

At least 60 beads were analyzed by applying the "analyze particle" command of the software.

Second, the QTL detected in each study were projected onto the consensus map, using the QTLproj command of the software.

First, a single consensus marker map was built by integrating the available genetic maps, based on common markers designated with common names between the maps, using the ConsMap command of the software.

Finally, the QTL meta-analysis algorithm, computed in the QTLClust command of the software, was used to determine the most likely number of meta-QTL on a given chromosome and to estimate their corresponding positions and confidence intervals.

In order to explore this possibility, the 'roctab' command of the software Stata [ 39] was used to obtain receiver operating characteristic curves (ROC) and to calculate the values for the area under the ROC curves [ 40] for the ability of the total OHIP-Sp score to predict each of the four outcomes studied.

First, the raw IVIM data were viewed using the fslview command of the FSL software and the image frames with the most excessive subject motion were marked and removed from the analysis.

The ConsMap command of the MetaQTL software version 1.0 was used to create the consensus marker map [ 20].

Calculation of the Gini coefficient and concentration index for health workforce financing was done using the inequal command of the STATA statistical software Release 11 [ 20].

As estimated using the 'sampsi' command of the Stata statistical software, release 6 [ 22], with these genetic frequencies and with 200 cases and 182 control individuals, the statistical power to detect ORs 2 and 0.5 would be as follows: 80.7 and 52.8% for ADRB2, respectively; and 88.6 and 78.1% for ADRB3, respectively.

Judging the predetermined SSR marker orders, through e-Landing, on the linkage map of chromosome 5, and estimating the practical recombination fractions between SSR marker pairs were conducted with the 'ripple' and 'map' commands of the computer software MAPMAKER/EXP3.0 (Lincoln et al.1992).1992

The survey commands of the statistical software Stata 10 was used to analyze the data considering the complex sample design.