Next, samples were combusted by flash combustion (1800 °C) on a CNS analyzer (EA 1110 Carlo Erba, Thermo Fisher Scientific, Waltham, MA, USA) coupled to an Isotopic Ratio Mass Spectrometer (Finnigan DeltaPlus, Thermo Electro GmbH, Bremen Germany) via an interface (Conflo III, Thermo Electro GmbH, Bremen, Germany).
A methane air flat flame reactor was designed to study the initial stages of combustion through flash pyrolysis of biomass and factors contributing to particulate emissions were examined.
In this study, the combustion characteristics of flash boiling spray was investigated under cold start condition in a spark-ignition direct-injection (SIDI) optical gasoline engine.
Nitrogen content of the defatted cottonseed meal was determined by flash combustion method using Flash EA, 1112 series, Thermo Finnigan elemental analyzer (Thermo Scientific, Mumbai, India).
Dried GF/F filters were pelletized in tin cups, and PON as well as isotope ratios were measured by means of flash combustion in an elemental analyser (Carlo Erba EA 1108) coupled to a mass spectrometer (Thermo Finnigan Delta S).
Biomass for tissue analysis was ground and analysed for total C and N on a soil combustion analyser system (Flash AlllZ, Thermo-Finnigan).
Flash auto combustion method was successfully used to synthesize nanoparticles of Zn0.5Co0.5Al0.5Fe1.46La0.04O4.
Aerosol combustion, especially for high-flash point materials, is a very complicated phenomenon inclusive of droplet evaporation, temperature increase, flame formation, flame propagation, and flame quench.
This method integrates four control parameters that significantly affect the fire risk, including the passing frequency and maximum sectional area of vehicles, the flash point and combustion heat of dangerous chemicals.
Nitrogen content of wheat straw, compost and casing layer was analysed using the combustion (DUMAS) method on a Flash EA 1112 Nitrogen Analyser (Thermo Scientific, Rockford, IL, USA).
