Sentence examples for combination peak from inspiring English sources

In this hypothesis, it must be inferred that the Si- OH -M bondSi- OH -MSi- OH -Mmilar to that of Si-(OH)-Si protonated bonds near 900 cm−1, such that those bonds will contribute to the IR combination peak near 4500 cm−1.

Molecular orbital calculations indicate that both Si-OH and Si- OH -Si bondSi- OH -SinalSi- OH -Si cm−1 (Kubonds and Sykes 2004), so that the OH givepsignalsved inear-(OH)-Si bonds will contribute to the IR combination peak near 4500 cm−1.

Use of the IR combination peaks at 4500 and 5200 cm−1 to determine water content of glasses is only possible when those peaks are well defined.

Additionally, combination peaks at (νdq, ν+ + ν−) ≈ (4, 2.5) MHz and (νdq, 2ν+) ≈ (4, 3.2) MHz were present (Figure 4c,d), similar to those observed for other Cu2+ binding proteins where the metal is coordinated by two His residues [47].

In terms of cost benefits for the proposed system combinations, peak shaving and 20% renewable energy penetration can realize savings of up to USD $150,000 per annum.

To compare the column combinations, peak distribution of the analytes in 2D space was plotted for all five ILC as shown in Fig.  3 below.

The results indicate that a combination of peak position shift and peak height change is the most difficult nonlinearity to calibrate.

Therefore, the height combination of peaks 1 3 was chosen as the signals for the quantitative calculation, rather than a single monoisotopic peak as previous approaches.

As shown in Figure 4C, the calculated standard curve from three pairs of sialylated glycans had a nearly linear relationship (R = 0.9893) over the full range (10 1 to 1 10) by the height combination of peaks 1 3, indicating that the DRAG strategy had a similar 10-fold dynamic range, comparable to other single-modification strategies while analyzed by MALDI-MS.

Then, in order to directly check the wind load combination effects, peak normal stresses in columns of a simple frame model were examined.

Attempts have been made to include flow duration and total expenditure of stream power, in combination with peak unit stream power, as important variables, but there has been minimal exploration of this hydraulic combination.