Sentence examples for coil holder from inspiring English sources

TMS was delivered to the cranial region of interest using a Magstim 200 stimulator (Magstim Co., UK) via a 70 mm figure-of-eight shaped coil held in place by a dedicated coil holder.

Following localization of the TMS site on the participant's scalp outside the scanner using Brainsight neuronavigation (see above), the participant was placed in the scanner and the TMS coil carefully fixed against the marked site on the head using a custom coil holder.

A custom-built, figure-of-8, MR-compatible TMS coil (30 mm inner diameter, 70 mm outer diameter, 15 turns each winding, 22.9 mH inductance, 4.7 kVA predicted maximal current at 100% stimulator output; from the MAGSTIM Company, Dyfed, UK) was carefully placed over the marked PPC site and fixed by means of an MR-compatible custom coil holder.

A set of 6 diaphragms with variable aperture mounted in the coil holders is used to align the MOT beams to precisely overlap in the middle of the glass cell.

The coils were held in place using coil holders mounted on the Brainsight Neuronavigation apparatus.

First, subjects were seated comfortably and the coil was positioned using a coil-holder (Brainsight, Rogue Research Inc ,Quebec Canada), at the scalp position at which Standard TMS induced motor-evoked potentials (MEPs) of maximal peak-to-peak amplitude in the target right first dorsal interosseus (FDI) muscle.

Each resonator system consists of a distinctive cantilever beam, one attached with four magnets and steel keepers, the other attached with a copper coil and stainless steel holder as the free end mass.

The head holder, eye coil, and recording cylinder had been implanted in surgical procedures that used sterile technique with the monkey under isofluorane anesthesia (Ramachandran and Lisberger, 2005).

Following initial training, monkeys were implanted with a head holder, eye coil, and recording chambers above V1 under general anesthesia and sterile conditions.

In this process a specially designed substrate holder, W-coil on SiC cylinder, is used for resulting in rapid heating-up of the substrate via the absorption of the microwave power and forming appropriated temperature profile for the dissociation of ferrocene/CH4 prior to the formation of CNTs in gas phase in adjacent to Ni-caps.

A cardboard holder above the loop coil was used to place a syringe with hyperpolarized [1-13C]pyruvate.