Other factors such as dump slope angle (slope inclination), natures of the dump materials (material properties), degree of compaction, dump height and changes in cohesion of interface materials have also been pointed by other workers [34, 48, 57].
When designed and applied properly, foamed asphalt provides a way of obtaining good coating on granular materials made from ash and hence adequate cohesion of pavement materials.
Samples prepared by in situ synthesis of carbon nanotubes (CNTs) in impregnated submicronic alumina are highly homogeneous and present the higher electrical conductivity (2.2 3.5 S cm−1) but carbon films at grain boundaries induce a poor cohesion of the materials.
It has long been recognized that the cohesion of composite materials, in low confinement, is strongly affected by the properties of the interfacial transition zone (ITZ) between inclusions and matrix.
The occurrence of planar slides in the study area depends on the shear-strength conditions of the failure surface and the cohesion of the materials involved, usually presented in the Malan loess and in reworked loess slope deposits.
So when making transition metal oxides anodes of LIBs, SBR+CMC binder has bigger cohesion of active materials with the copper foil that was more suitable than PVDF binder.
To recover the internal cohesion of the material is a very important topic in the conservation of historical architecture because alteration phenomena often produce the detachment of large areas of plasters (lacuna).
To produce the final resistance and cohesion of the material, the dried samples were subjected to a firing process in a kiln that caused sintering of the grains and change in their density and porosity.
The angle of internal friction of JMSS-1 is approximately 40.6°, and the cohesion of this material is approximately 0.33 kPa. Figure 5 shows the Mohr stress circles which were used to determine the angle of internal friction and cohesion for of JMSS-1.
The outlets of coal storage and feed containers in coal preparation and power plants are prone to blockages due to cohesion of the extruded materials.
Table 2 shows that the range of the angle of internal resistance and cohesion of the slope materials are 8° 37° and 13 34kN/m2 respectively.
