Sentence examples for coatings sample from inspiring English sources

Table 1 Contact angle measurements for different surface coatings Sample Contact angle No coating (quartz only) 45 ± 2° Un-doped ZnO 104.5 ± 5.9° Al-doped ZnO 3% 91.3 ± 1.0° Al-doped ZnO 7% 118.70 ± 0.63°.

The corrosion distribution along a coil-coating sample formed by deep-drawing is reported.

The initial Coulombic efficiency of 3 wt% LaNiO3-coating samples reaches the maximum of 70%and65%5% at 0.1 C and 1 C rates, respectively.

Polarization curves of coated samples, detached coatings, AISI304 substrate and commercially pure titanium (grade 2), are also reported and discussed.

In order to compare the anticorrosion ability of the ESol + TUA coating with other coatings, the samples of ESol and ESol with diethylenetriamine (ESol + DETA) coatings have also been prepared.

The experiment was designed to evaluate the role of the process speed on the depth of remelting, comparing cases of a different coatings and sample thicknesses using Near-infrared (NIR) camera.

For the SSP1-Eu coatings, the sample with Si/Eu = 7/1 shows an exception.

Besides pure OIH coatings, HDGS samples were coated with OIHs doped with Cr3 +, which was tested as a corrosion inhibitor.

The results show different fracture modes for the thinner and the thicker coating samples; the multiple transverse cracks, vertical to the interface between the coatings and the substrates, in the coatings are the main fracture mode for the samples with coatings thinner than about 200 μm, while the interface crack is the main fracture mode for the samples with coatings thicker than about 300 μm.

To assess temperature response of the coatings, the samples were immersed in saline solution at room temperature and aboveT t, separately.

Parallel to the morphological improvement in the coatings, the samples exhibited an improved corrosion performance.