Sentence examples for coatings coating from inspiring English sources
The present overview is a generic summary of the topic trying to comprehensively cover many important related aspects and to give to the reader a general knowledge about the technology, formation of the coatings, coating materials with their properties, and industrial applications of the coatings.
In this study, two MCrAlY coatings, coating A (10 wt.% Al, 20 wt.% Cr) and coating B (7 wt.% Al, 28 wt.% Cr), were tested in 48-hour cycles at 900 °C in a sodium potassium sulphate environment with and without SO2 (500 ppm).
The images show the PVDF bi-component fibre bundles framed by the much larger (in fibre diameter) PE monofilaments; the initial SEM in this figure did not reveal any distinct differences between the coatings, coating A is difficult to detect as it is more of a blurry feature on the fibres and coating B is mainly detected closer to the warp intersections where it seems to have accumulated.
The coatings obtained from cationomer polyurethanes (more frequently termed "cationic polyurethanes" in reference papers) were found applicable as waterborne polyurethanes in the past years for the production of environmentally friendly lacquers, adhesives and protective coatings, coating base paper, ink jet printing base paper, etc. [ 1– 3].
UHTCs based coatings (ZrB2 SiC coating and ZrC SiC coating) are prepared on the surface of PIP-C/SiC composites by slurry and CVD method, and the thermal stability is one of the key issues for C/SiC composites.
Stress and weight loss profiles for dense coatings, a coating that contained small (∼1 μm) pores, and a coating that contained small (∼1 μm) pores and macrovoids (∼200 μm) are compared.
The development and selection of coatings or coating combinations is a complex and costly task.
The fracture resistance of ultra-thick LAFAD coatings vs. coating architecture will be discussed.
Mechanical damage to the coatings initiated coating delamination and substrate corrosion.
Furthermore, functional surfaces can contribute to an increase of the adhesive strength of coatings and coating systems, respectively.
Thermal cycling test shows promising strain tolerance behavior for the segmented coatings, whereas coating without segmentation could not sustain even for its first thermal cycle period.
