Sentence examples for coating which has from inspiring English sources

Both fuels are contained in a structure of triple isotropic coated layers, TRISO coating, which has been proven to retain fission products up to 1600 °C and is expected to remain intact for hundreds of thousands of years after irradiation.

This goal can be achievable by adding some materials to the HA coating, which has already been done to improve its final coating characteristics.

In these studies we have used a recombinant human acetylcholinesterase enzyme coating, which has better reproducibility than other commercially available enzymes.

The PEO treatment generated a thermally-insulating, porous ceramic coating, which has a highly porous, rough surface that is favourable for incorporating polypropylene melted by FSSW.

Using Advanced Semiconductor Analysis ASAA) software, we optimize a double-layer anti-reflective (AR) coating, which has an additional SiOx film on the top of the existing indium tin oxide (ITO) coating.

The modified HA fillers were obtained to be uniformly distributed in the HA/PEEK coating, which has better properties of tensile strength and fracture toughness than those of the unmodified specimen.

The results indicated that ALN-HA composite coating, which could induce higher bone-implant contact (BIC) ratio, bone mass augmentation, BMD, and implant stability in the peri-implant region, was more potent on peri-implant bone, while RIS-HA composite coating, which had significant systemic effect, was more potent on non-peri-implant bone, especially lumbar vertebrae.

All test organisms avoided settling on the SHC 3 coating, which had large pores of ∼350 nm in diameter and small pores in the range of 10 50 nm.

In dry sliding, the friction of coated surfaces was about the same as for uncoated surfaces, except for the 1-µm coating, which had higher friction.

Laboratory evaluation of a sample coating, which had been heated to 540 °C for 150 h, demonstrated that the coating was thermally stable.

However, the solution with the ratio of 1 1 yielded a coating which had lower protection efficiency than single poly(pyrrole) film.