Sentence examples for coating transfer from inspiring English sources

The results obtained indicate that, in the case of coatings with BN(h) content higher than 11 vol.%, the wear mechanism is a mild adhesive wear mechanism (adhesive ploughing) with high plastic strain of the coatings and low coating transfer to the ball.

A mild adhesive wear mechanism (adhesive ploughing) was found for the samples tested at room temperature, whereas for those tested at higher temperature a mixed adhesive and fatigue wear mechanism, accompanied by a large plastic deformation of coatings and high coating transfer to the ball were observed.

This review highlights various factors involved in the successful design of balloon-based delivery systems, including drug release kinetics, matrix coating transfer, transmural drug partitioning, dissolution rate and release of unbound active drug.

The various thermal paths from the GaN gate junction to the case are carried out for heat dissipation by spreading to protective coating; transferring through the bond wires; spreading in the lateral device structure through the adhesive layer, and vertical heat spreading of silicon chip bottom.

The various thermal paths from the GaN gate junction to the case dissipate heat by spreading it to a protective coating; transferring it through bond wires; spreading it laterally throughout the device structure through an adhesive layer, and spreading it vertically through the bottom of the silicon chip.

Afterward, plasma was carefully removed from tubes without shaking the buffy coat, transferred to plain polypropylene tubes, and centrifuged at 16,000 g (+4ºC) for 10 minutes.

Advertising suggests that such a coating would transfer some of these diamond-like properties to the coated stone, hence enhancing the diamond simulant.

The hydration of the SiOSi chains in the coating and transfer layers resulted in the formation of two OH-passivated surfaces at the contact interface that led to low COF.

Take one fish cake, roll it in the flour to coat, then transfer it to the egg bowl, coating it all over.

Structure analysis revealed that surface of the coating was transferred from individual pancake or craters-based structure to cluster-based structure with increasing the voltage of the secondary step process.

An equal number of Matrigel inserts and Control Inserts (no Matrigel coating) were transferred into a 24-well plate and were rehydrated by adding 0.5 ml warm serum-free culture medium onto the interior of the inserts and incubating in a tissue culture incubator at 37°C for 2 h.