Sentence examples for coating test from inspiring English sources

Prototype pigmented systems were applied and cured and characterized by FTIR, SEM/EDX and were evaluated using standard coating test methods.

Tanned milkfish skin using 25% concentration of true indigo has the best quality based on the criteria: rub resistance on wet coating test (3.83%) and dry coating test (4.42%), fastness to perspiration (4.75%), tensile strength (1 843.53 N · cm 2), elongation (47.61%), and skin tissue micrograph photos showing better display of collagen fibers.

The coating test conducted at 900 °C for 100 h in argon showed that the Al2O3 layer changed little during annealing and could effectively prevent the diffusion of Fe and Cr from the SS substrate to the upper Ni layer.

The measured galvanic corrosion currents between coating and substrate indicated that WC Ti0.72Al0.28N coating showed the best resistance of the coating tested.

Similar bonding features were also observed in the deposited splats, indicating the splat on coating tests to be indicative of the coating build-up process.

A wear rate as low as 1.2×10−18 m3/N m was determined for the coating tested at 25 °C, which is approximately one order of magnitude and three times less than those found from the tests performed at 400 °C and 450 °C, respectively.

During the Future Advanced Rotorcraft Drive System FARDSS) program, the Aviation Development Directorate (ADD), Aviation Applied Technology Directorate (AATD), Bell Helicopter Textron Inc., University of Toledo and the Aristotle University of Thessaloniki worked together to perform bearing coating tests.

Among the different coating tested, the film ending by PSS/PAH exhibited an excellent cellular biocompatibility and appeared to be the most interesting surface in terms of cellular adhesion and growth.

The wear resistance of the HVOF sprayed WC-12Co + 6% ETFE coating tested in acid environment was almost one and a half times bigger than that of dry sliding condition, but the plasma sprayed WC-12Co + 6% ETFE coating tested in acid environment showed a lower wear resistance when compared to the result of the experiment performed on dry sliding condition.

The factors affecting the oxidation kinetics of the coating were studied by comparing its oxidation behaviour with that of the pack Fe-aluminide coating tested in the same ultrasupercritical steam.

It is found that the creep strength of the diffusion coating tends to be higher than that of a similar coating tested previously by Pan et al. [Pan D, Chen MW, Wright PK, Hemker KJ. Acta Mater 2003 51 2205].