Sentence examples for coating operation from inspiring English sources
The main emphasis was on examining the conditions necessary for the successful coating operation and characterizing the as-deposited coatings for the thickness, uniformity and surface morphology.
An experimental investigation of the flexible blade/gravure roll coating operation is presented for a wide range of operating conditions.
Coating operation of particles smaller than 100 μm is very often troubled with particle agglomeration and adhesion due to the excessively high binding strength of coating materials and to electrostatic charging.
The coating operation is carried out by a continuous liquid polymer impregnation (LPI) of carbon fibers with polyorgano(bora)silazanes. In order to reach an optimum behavior of the polymer in the LPI operation, detailed rheological studies were carried out.
Reverse roll coating is probably the most widely used coating operation, yet its full potential has not been exploited as it is shown in this paper which considers operation with a negative gap.
This work provides a comprehensive set of experimental data describing this important coating operation, usually carried out at large speeds ( > 2 m/s) and with low-viscosity liquids, i.e. large Re.
Coating operations were performed on low porosity sodium sulphate cores (180 350μm) coated with aqueous solutions of Na2SO4 using Dextrin as binder in three top-spray fluidised bed scales, i.e. a small-scale (type: GEA Aeromatic-Fielder Strea-1), medium-scale (type: Niro MP-1) and large-scale (type: GEA MP-2/3).
Air emissions from surface coating operations result from the evaporation of the organic solvents in the coatings and consist primarily of volatile organic compounds (VOCs).
MEAD CORP., Dayton, Ohio, the stationery and office products manufacturer, has agreed to buy the carbonless coating operations of a unit in North America of the Moore Corp., Toronto, for an undisclosed amount to add capacity.
Implications for coating operations are discussed.
Possible application to control of coating operations is pointed out.
