Sentence examples for coating contact from inspiring English sources

The phonon phason coupling field and elastic field in the coating and semi-infinite substrate will be derived based on the axisymmetric general solution and the complicated coupling field of quasicrystals in coating contact space is explicitly presented in terms of elementary functions.

Once nanotubes have passed the seed coat, contact with the radicle and other seedling organs is possible.

That is because introducing a coated implant not only brings the coating into contact with the body environment but also the interface that controls the adhesion.

All the coated systems and in particular the nickel-aluminide coating in contact with the Solar Salt up to 1000 h performed much better than the uncoated material as they exhibited lower weight variations and no evidence of significant spallation.

For a Cu-dotted oxide coating, the contact angle is too small to be precisely measured directly by a contact angle gonoiometer because water spreads on the coating surface.

The techniques used showed that with only one RGO coating, the contact between the RGO sheets is not good and more coatings were needed to assure good electrical and electrochemical properties.

Coating the contact surfaces with alumina provides the required electrical insulation.

Results show that for both the modified TiO2 nanoparticles and the as-prepared composite coating the contact angle and sliding angle of is up to 152° and 0°, respectively.

The superhydrophobic A/B/MSN2 coating (water contact angle: 153°, sliding angle: ⩽5°) showed excellent antireflection in the wavelength range of 400 2000 nm, especially in the wavelength range of 742 1573 nm where the transmittance of glass substrate is significantly lower.

These applications are: the selective coating of contact materials in reel-to-reel continuous plating lines, the continuous copper plating of printed circuit boards, the high-speed plating in product-specific plating tools integrated into an inter-linked production and the electroforming of microstructures.

As much smaller nano-papules/spheres with poor directional consistency stacked densely on the continuous zone of Q1, Q2, and Q3 coating, the contact area between the water droplet and the coating surfaces increased at some extent, and the adhesion of water droplets on Q1, Q2, and Q3 coating was greater than that of P2 coating[29, 30].