Sentence examples for coat suspension from inspiring English sources
The tubes were then centrifuged at 15,000 g to obtain the buffy coat suspension.
Simultaneously, coat suspension culture dishes with 10 mg/ml of FN and 100 mg/ml of P-L-L, respectively, in PBS at 4°C overnight, followed by coating with blocking buffer at 37°C for 1h.
(#430591, Corning) Protocol: Coat suspension culture dishes with 25 mg/ml of goat anti-mouse IgG (H+L) at 37°C for 2 h and block the dishes with blocking buffer at 37°C for 1 h.
To separate peripheral blood mononuclear cells (PBMCs) from polymorphonuclear cells, buffy coat suspensions were carefully layered onto Accu-Paque™ (Accurate Chemicals, Westbury, NY) density gradient solution (density - 1.088 g/mL; osmolarity - 350 mOsm) and centrifuged (380 × g for 30 min).
This study shows the effect of the coating suspension composition on the properties of catalytic coatings, as well as how CO2 conversion, methane selectivity and catalyst stability are affected by the architecture of the structured catalyst.
Membrane pre-treatment and the addition of binder to the dip-coat suspension appear to be crucial in the process.
Graphene sheets can be randomly deposited on the prefabricated electrodes by drop-coating suspension to fabricate graphene sheet-based electrical circuits.
The sedimentation of insoluble particles in the coating suspension is one of the main problems during the formulation of the coating fluid.
The effects of inlet air temperature, coating suspension flow rate and atomizing air pressure on particle growth were analyzed by a central composite rotatable design (CCRD) of experiments.
An experimental design, totalizing 11 experiments, was defined to analyze the influences of spouting air temperature, coating suspension flow rate and atomization air pressure on particles growth rate and coating process efficiency.
The work was performed in two stages: 1) monitoring of the fluidization regimes during the development of the coating process without control and 2) control of the airflow rate and of the coating suspension flow rate using PI controllers.
