We thus confirm that CNCs in solution progressively assemble into helical layer stacks that compress as water is extracted, assembling into ordered chiral films on top of the substrate.
At the end of the period of exposure, 170 µL of CNC-nitric oxide solution were transferred into a black 96-wells plate and fluorescence was measured by using Victor-2 multimode plate reader with a 485 nm/535 nm excitation/emission filter (Perkin Elmer, Waltham, MA, USA).
Syndiotactic polystyrene (sPS) composites filled with well-dispersed carbon nanocapsules (CNC) were prepared through solution blending along with ultrasonication.
When the matrix phase (deionized water) is replaced with a simulated cement paste pore solution, the CNCs begin to agglomerate at a lower concentration (approximately 0.18% by volume).
Moreover, the addition of 40% Gly significantly increased the values of G′ and G′′ for CNCs in NaCl solutions.
Dramatically, the G′ and G′′ values were raised and tan δ (<1) decreased with the increasing addition of NaCl, indicating that the elastic properties of CNCs in NaCl solutions continuously strengthened, thereby the gel-like response of the network was enhanced.
The lower bound for MSE of a modified EOUQ with the CNC index assignment is D CNC lower bound = 1 3 − 2 − n − 1 + 2 − 2 n − 2 + 2 − n ∑ i ∈ V z n 2 i · α n i, I r i − ∑ i ∈ E c j p n π n CNC j | π n CNC I 1 + ∑ i ∈ E i p n π n CNC j | π n CNC I 1 + 2 − 2 n ∑ i ∈ E c j + j 2 p n π n CNC j | π n CNC I 1 + ∑ i ∈ E i + i 2 p n π n CNC j | π n CNC I 1. (20).
Nevertheless, we also define dense CNCs (d-CNCs), which are not porous, amorphous CNCs (a-CNCs), as well as flexible CNCs (f-CNCs) and rigid CNCs (r-CNCs).
Nanocomposite films were fabricated by dispersing the CNCs and cationically modified CNCs (mCNCs) in CMC matrix through solution casting.
The CNCs with the highest anisotropy are expected to assemble at the edge of the solution where the radial flow induces CNC alignment, which competes with helical layer formation.
