Sentence examples for cm current from inspiring English sources

DM and CM current paths flowing to batteries are analyzed through the modeled equivalent circuits.

The results show that the batteries voltage fluctuation range without filter due to DM and CM current is higher than that with filter.

The optimum conditions for the process were identified as groundwater initial pH 5, flow rate = 4.3 l/h, inter electrode distance = 2.8 cm, current density = 5.78 mA/Vm2, A/V ratio = 0.248 cm−1.

Under the following conditions, a concentration of as high as 65.67 g/L of active chlorine was gained: ruthenium oxide-coated titanium anode (AA = 24 CMZ); titanium cathode AA/AC = 1.33; inter-electrode distance 0.5 cm; current density 35 A/cm2; temperature 20°C; concentration of NaCl aqueous solution 3 M; time 2 h.

Under the following conditions, a concentration of as high as 65.67 g/L of active chlorine was gained: ruthenium-coated titanium anode (Sa = 24 cm2); titanium cathode, SaSc = 1.33; inter-electrode gap, 0.5 cm; current density, 35 A/dm2 ; temperature, 20°C; concentration of NaCl aqueous solution, 3 M; time, 2 h.

EMI is a major challenge to design of high power drive system in EVs due to large dv/dt and di/dt outputs of power devices in power inverter and/or converter, which can generate conducted DM and CM current through parasitics to interfere key components such as batteries and drive motors, low voltage system in EVs and nearby vehicles.

Procedures map to ICD-9-CM, Current Procedural Terminology, and Healthcare Common Procedure Coding System codes.

The linearity and detectability of the chemosensor fabricated at low (4 mA cm-2) current density were favorable; however, at high (6 mA cm-2) current density those parameters were very limited owing to the formation of a thicker sensing film with less accessible imprinted cavities.

The high beam purity results in a useful treatment depth of ~9 cm, using current capture compounds.

Using optimized photosintering conditions, a sheet resistance value as low as 150 mΩ/□ (resistivity of 9 μΩ cm) and current carrying capacity of 280 mA for a 300 μm wide trace was achieved.

In this step, the specific scale (which was 2 cm in current study) was defined for the software and, based on the defined scale, the area of white and black parts was automatically calculated by software.