Sentence examples for close to interface from inspiring English sources

Cohesive failure, close to interface, was observed for the joints with surface treatment (P120, P50 and P30).

The simulations also display a high accumulation of TFSI anions and Li+ cations close to interface regions.

A small contribution of cohesive failure mode (close to interface) could be a possible reason for higher bonding strength at particular surface roughness of adherend.

The intermediate phase observed close to interface indicates the existence of an instable, pre-adaptive martensite phase with a short stacking period.

Mixed failure between the adherend and adhesive occurred when the adherend had lower surface (0.54 ± 0.15) and then failure mode partially shift towards the cohesive failure mode close to interface when the surface roughness increases.

For the interface region of coating and bond coat, fracture toughness in the coating close to interface ranges from 0.11 to 0.81 MPa m1/2, and residual stress varies from − 5 to − 30 MPa, which are consistent with available data.

The use of dynamic adjustment of number of elements and order of approximation gives the possibility of a dynamic meshing procedure for a better resolution in the areas close to interfaces.

The explanation is that the E5C-EDTA-Mn2+ label is on the far side of HPr from the interface, and in some encounter complexes this label is much closer to interface residues than in the native complex.

For a completely blocking substrate the normalized tracer fraction is expected to be constant in LSC close to the interface and to be zero beyond the interface throughout the substrate (compare dotted line in Figure 4 ).

This residue is distant from the active site but close to the interface between the catalytic and regulatory domains, so that this interface is altered in the activated protein.

The strain rate of this remote plastic zone in the interface layer increases and its area enlarges when the crack gets close to the interface.