Sentence examples for cleavage forces from inspiring English sources

Moreover, cylindrical joints are associated with high substrate strength in the radial direction, meaning that peel and cleavage forces have different effects compared to single lap joints.

In addition, due to the geometry of the test specimens and the block shear fixture, peel and cleavage forces in the joint are minimized.

Cylindrical joints are associated with high substrate strength in the radial direction, meaning that peel and cleavage forces have different effects compared to simple lap joints.

The cleavage strength of polycrystals.

Figure 4: Nanomechanical cleavage and force measurements on a 23-layer MoS2.

In conclusion, our data indicate the enhancement of FasL cleavage and/or forced expression of sFasL may have therapeutic applications in preventing RGC apoptosis in glaucoma.

When these extracts were analysed by immunoblotting, there was a dramatic up-regulation of STAT3α cleavage during forced involution – reaching a maximum around day 3 of involution for wild type mice (Fig. 2E, C-terminus STAT3α panel).

Selected computational research activities on the applications of gradient enhanced model in the computation of the Weibull stress, w σ, which represents a cleavage fracture driving force and the strength of circular hollow section (CHS) joints with and without the high strength grout including their failure phenomena are briefly discussed.

Evidence that these additional attachment points might affect adhesion dynamics came from a recent study by Zhang et al. who identified a C-terminal fragment of talin potentially liberated by exposure of a hidden calpain-sensitive cleavage site by force-induced conformation changes of talin.

Because the two adjoining S layers are bonded by van der Waals forces, its cleavage plane interval is 0.616 nm.

In order to study the effect of cleavage and shear deformation on cutting force, the (110) crystal plane where the most obvious cleavage and shear deformation were observed during the nanometric cutting process is taken as an example (Fig. 7).