Sentence examples similar to clamp filter from inspiring English sources

Platelet activation in the O'Brien test did not differ among the four different treatment groups at baseline (before clamp) (average filter closure time 61.9 ± 6.3 s; retained platelets 78 ± 6.3%, n = 40).

GABAB responses were evoked by fast application of baclofen and recorded with an Axopatch 200B patch-clamp amplifier; filtering and sampling frequencies were set to 1 kHz and 5 kHz, respectively [ 29].

Inactivation properties were investigated by incorporating a depolarizing pre-pulse of 5 ms duration and variable amplitude immediately prior to the test pulse, which had a fixed magnitude of 100 mV from rest and a duration of 70 ms. Clamp currents were filtered over the bandwidth DC-10 kHz (8-pole Bessel filter) and digitized at 50 kHz using custom written software.

- Open the bio-filter clamp and read IBP (end-expiration value) when the meniscus has stabilized after about 10 s. - Close clamp after IBP measurement and place the FoleyManometer in its drainage position.

Outputs from these and the clamp amplifier were filtered (8-pole Bessel) and recorded at 20 Hz on a PC via a CED micro 1401 interface and Spike 2 data collection program (Cambridge Electronic Design, UK).

In all four, for different reasons, the filmmakers foreclose the characters, clamp down the implications, filter out the context, and thereby fake the results.

The hyperglycemic clamp significantly shortened the filter closure time and enhanced the percentage of platelets retained in the placebo group (Fig. 1 B and C).

Tighten the bolt on the clamp holding the fuel filter.

Use a clamp to hold the filter to the mic stand.

Use a 10 mm (13/32-inch 13/32-inch remove the bolt that sockets toe clamp holding the fuel filteremovehe car.

Current-clamp recordings were filtered at 2.5 kHz and sampled at 5 kHz and voltage-clamp recordings were filtered at 5 kHz and sampled at 10 kHz using the program Pulse-8.53 (HEKA Elektronik).