Sentence examples for cladding components from inspiring English sources

This paper presents the assessment of experimental data for electrical and thermal performance evaluation of photovoltaic (PV) systems integrated as cladding components into the building envelope, giving input to modelling and analysis work.

All plastic displacements can take place without any restricting effects from the connections or cladding components.

Ferritic/martensitic steels are candidate materials for structural and cladding components designed for Generation IV reactors because of their superior resistance to radiation damage at the high operating temperatures envisioned in these reactors.

Meanwhile, internal forces in cladding support components only considering local behaviors were extracted by using local wind loads based on quasi-static assumption.

By ignoring the contribution of overall behaviors of main structural frames, internal forces in cladding support components may be underestimated following current wind load codes or recommendations.

Considering only the local behavior will underestimate the axial forces in cladding support components significantly, which may lead to buckling failure.

In this paper, a method was proposed to separate the internal forces of cladding support components due to wind-induced local and overall behaviors and investigate the corresponding contributions for the largest internal forces.

Based on the pioneering work of Ding and Tamura (2013); Ding et al. (2012), a new method is proposed to estimate internal forces in cladding support components due to wind-induced overall behaviors directly.

The results demonstrate that the bending moments and shear forces in cladding support components are dominated by local wind loads acting on the corresponding tributary areas, and the axial forces are caused by the overall displacements of the main structural frame.

The copper-clad component resembles a spyglass and produces a plasma that focuses the accelerator beam down to a point that can heat a spot of foil to 30,000 degrees Celsius in less than a billionth of a second to create a substance called warm dense matter that researchers are eager to study.

Accordingly, it can be concluded that cold spray is a feasible and practical method to achieve thick copper cladding on tokamak component.