Sentence examples for cl solution from inspiring English sources

In order to obtain quickly the influences of blast furnace slag and water-binder ratio on the leaching behavior of cement-based material and its corrosion resistance in water environments, an accelerated calcium leaching experiment on a slice specimen with slag-cement pastes in 6 M NH4 Cl solution was carried out.

Previous work on F and Cl solution behavior in aluminosilicate melts (Mysen and Virgo [1985]; Kohn et al. [1991]; Schaller et al. [1992]; Zeng and Stebbins [2000]; Mysen et al. [2004]; Zimova and Webb [2006]; Baasner et al. [2013]) have shown that F preferentially bonds with tetrahedrally coordinated cations such as Al and Si.

In fact, other authors have seen that the lid roughness is reduced with the peroxide use, CL solution without preservatives [ 49, 50].

Cu OAc 2 was obtained from Université de Sherbrooke, QC, Canada and CuCl2 was obtained from Washington University, MO, U.S.A. Porphysomes in PBS were diluted 1 1 with 0.1 M NH4OAC (pH 5.5), before adding a small volume of aqueous CuX2 (X = OAc, Cl) solution and incubating at 60 °C for 30 min. Radiochemical purity and yield were assessed on a radio-UPLC (Waters, Milford, MA, U.S.A).

COL solutions resulted in functional and histological impairments when compared with CL solutions.

All five studies that evaluated metabolic changes found statistically significant increases in serum Cl, decreases in pH, and larger base deficits with standard Cl versus low Cl solutions.

During preliminary recordings, we found that inside-out patches held at more negative or positive membrane potentials using the same symmetrical Cl– solutions used for macroscopic current recordings were unstable over these prolonged recording periods.

Therefore, 2 mL of 0.01 mg % of FMOC-Cl solution was chosen as the optimal volume of the reagent.

2.0 mL of borate buffer (pH 7.8) followed by 1 mL of NBD-Cl solution (0.2% w/v) and were mixed well.

Therefore, 1.2 mL of 0.2% w/v NBD-Cl solution was chosen as the optimal volume of the reagent (Figure 5).

To each flask 1 mL of borate buffer (pH 10.7) followed by 1.2 mL of NBD-Cl solution (0.2% w/v) were added and mixed well.