Sentence examples for check the capability from inspiring English sources

In order to check the capability of invariance to lighting condition and face orientation, which have been better solved by 3D deformation approaches.

The intention of the paper is to check the capability of a discrete element method (DEM) to simulate a pattern of quasi-static shear zones in initially dense sand.

After the training process, to check the capability of the network, we only used, as input of the network, a data set which had been excluded in the training process.

Despite the noisy signal obtained from the DIC technique, the comparison between the two monitoring methods at least allows us to check the capability of the DIC to follow the same trend obtained from the strain gauges.

We analyse tilt and environmental parameters collected near Strasbourg, France, since 1997 to study the source of the tilt changes and check the capability of the ATFS to compensate them.

In addition, we have also calculated the RMSD of backbone heavy atoms (bRMSD) to evaluate the robustness of our approach and the RMSD of all heavy atoms (aRMSD) to check the capability of our method in predicting side chains.

A large scale heating test is analysed to check the capabilities of the implemented model to simulate an actual problem involving complex thermo-hydro-mechanical stress paths.

Secondly, we check the capabilities of the nesting procedure to facilitate regeneration of the inertial-range turbulence structure by the small-scale LES.

In order to check the capabilities of this technique, we present here the results that we have obtained for the characterization of two phase flows in horizontal and vertical tubes.

No other means to control and measure thickness of the paint and ratio binder-pigment was implemented since this study wants to check the capabilities of this flowchart method on actual artworks where all those parameters are not likely to be easily determined.

In the subsequent paper, Hoang et al. (2012) investigate the structural behaviour of T-components made by joining two aluminium extrusions using aluminium self-piercing rivets and checking the capability of the previous SPR model proposed for large-scale shell analyses.