Sentence examples for charge detected from inspiring English sources

The charge detected was found to be predominantly negative.

Test results have shown that there is a direct correlation between both the wear rate and coefficient of friction with the magnitude of charge detected.

Previous research, using a pin-on-disc (POD) tribometer [1 3], has shown correlations between wear, friction and temperature with electrostatic charge detected by sensors mounted a distance from the contact but focused on the disc wear track.

Although this experiment demonstrated that single primary electrons could be detected the chip did not provide information on the arrival time of the electron in the sensitive gas volume nor did it give any indication of the quantity of charge detected.

We found that ATP generation was slow down in T. tencongensis at the temperature as high as 80°C, according to the energy charge detected (data not shown).

Because a negative bias was applied to aerosolized ions within the DMA, only nanoparticles that acquire a positive charge were detected (the fraction with positive charge is known and does not adversely bias the distribution).

This charger operates on the well proven principle of continuously monitoring the on-charge battery voltage and terminating the charge only when the stabilized conditions occurring at the top of charge are detected.

Using four electrode (base, emitter, collector, and substrate) IBIC measurements at the Sandia Nuclear Microprobe Facility, we found that the largest fraction of the induced charge occurred on the collector and on the substrate; significantly less induced charge was found on the base electrode, and practically no induced charge was detected on the emitter.

When the cathode rays were magnetically deflected so that they did not pass through the holes, no charge was detected.

The highest voltammetric charge was detected from the IrO2-Ta2O5/Ti anode prepared through baking at 90 °C for 180 s.

A long lifetime and a relatively high voltammetric charge were detected for the IrO2-Ta2O5/Ti anode with the Ti pretreatment of etching in the NH4HF2-based solution for 30 min.