Sentence examples for characteristics of the machine from inspiring English sources

The kinematics model and characteristics of the machine were derived and analyzed.

Modal analysis and dynamic compliance analysis were also conducted to evaluate stiffness and dynamic characteristics of the machine.

In other words, this constant magnetic flux will not be affected by switching transients due to highly inductive characteristics of the machine.

The performance characteristics of the machine such as rotational speed, generator output as well as stability for wind speed changes are described.

Design characteristics of the machine are given and experimental results obtained from the variation of the five most influential parameters are presented.

Hence, this study presents an NC machine time estimation model for machining sculptured surfaces, considering such dynamic characteristics of the machine.

The investigation revealed that, in all the field conditions, differences in the characteristics of the machines and/or in working cycles were the most relevant uncertainty components.

It was found that variations in performance characteristics of the machines predominantly resulted from the differences in the characteristics of hazelnuts and the different adjustments performed on separation systems of the machines.

In addition, since power and efficiency are important for present applications, the present tool can be used to estimate the data for those characteristics of the machines and even it can be beneficial for the applications, where a nonlinear relationship among the power generation, generator efficiency, speed and load is required.

It could have been better, of course, if we had a bigger cascade because then even the process of enrichment would have been assessed, not only the mechanical characteristics of the machines.

Quadratic polynomials are employed to construct response surface (RS) model, which reflects the relationship between design inputs and structural response outputs, according to the response outputs of these samples obtained by analyzing the dynamic and static characteristics of the machining centre at these samples with the software ANSYS.