Sentence examples for characteristic standard from inspiring English sources

An additional result of running validation plates is that they provide the researcher the characteristic standard curves (also referred to as 'calibration' or 'dilution' curves) for each target.

The estimator of the characteristic standard deviation function SD is then determined by fitting the linear function SD = a + bY mean to the experimental points at the logarithmic scale; (Eq. (1), Y m is the sample mean).

On the basis of this principle we developed the method of analysis, incorporating the subroutines calculating the characteristic standard deviation function, boundaries of the probability intervals for selected set of values, tests of normality, calculations of skewness and kurtosis, etc. (c.f. Methods section).

Our observations indicate that the change in biological state of the matter is usually reflected in the proportionality coefficient b, while the change in technical parameters is frequently correlated with the coefficient a. Consecutive sampling provides good estimator of the characteristic standard deviation function.

The coefficient values calculated for the individual pairs and the mean of five pairs are shown in Table 1 (Hybridization 1 vs. hybridization 2) and a typical low dispersion pair C1a vs. C1b is plotted in Figure 4; Figure 5 shows the experimental standard deviations and the regression curve, representing the characteristic standard deviation function (1).

Calcification of substrate is a first characteristic and standard marker for osteogenic differentiation process (Knezevic et al. 2010; Domingos et al. 2013).

The absorption and emission characteristic of standard as well as compound 16 were measured at different concentration (2, 4, 6, 8 and 10 ppm level).

As it has been largely published, tests performed as a function of time have as a common characteristic high standard deviation values.

Culture on silicone rubber surfaces has been shown to partially overcome the chondrocyte dedifferentiation characteristic of standard culture on rigid polystyrene.

The higher dosage is required to sustain therapeutic plasma concentrations of levodopa and minimize the peak/trough fluctuations characteristic of standard IR formulations.

The area under the receiver operating characteristic curve (standard error) and the 95% confidence interval were 0.629 (0.03) and 0.572 to 0.687 (P <0.001), respectively.