Sentence examples for changes of surface pressure from inspiring English sources

We used a monolayer composition mimicking that of MOM and MOM/MIM regions, and we characterized the insertion of the BCL-2-derived peptides by monitoring the time-dependent changes of surface pressure at a constant film area.

The spatial distribution of surface pressure changes during 1963 2011 with day-to-day changes in SWS shows a pattern resembling the NAO.

The dependence of surface pressure on the overall surface area leads to a straightforward determination of the phospholipid surface area and its change upon binding of the chemicals.

In the work presented here, the reaction of a monolayer of POPG with gas-phase ozone was found to be similar to that of POPC. Figure 4 shows the changes in surface pressure observed when a monolayer of POPG with an initial surface pressure of ∼20 mN m 1 is exposed to ozone.

If the peptides are present in monolayers with lipids, then changes in surface pressure suggest both reaction of the peptide and, if the lipid is unsaturated, reaction of the lipid may occur.

Calculation of the tilt angle shows that it changes with surface pressure.

The changes in surface pressure for this mixture are presented in Figure 5.

However, the stimulatory effect of NaCl could also be interpreted as a salting out effect of the peptide, i.e. an increased concentration of the peptide at the interface which could change the surface pressure independently of the association between Aβ and GalCer-HFA.

An effective complexation of Pluronic and αCD was evidenced as a change in the surface pressure of the π-A isotherm of Pluronic on a subphase of CD solution and the apparition of new peaks in the X-ray spectra.

Figure 2 shows the change in surface pressure when a monolayer of SP-B(1 25) and a monolayer of SMB, at 37 °C, is exposed to ∼1 ppm of gas-phase ozone.

The change in surface pressure when a monolayer of SMB and DPPG, 1 12 by molecule, is exposed to ozone is shown in Figure 5.