Sentence examples for changes in the boundaries from inspiring English sources

In its opinion, the court said yesterday that changes in the boundaries of the special zoning district enacted by the city in 1983 had allowed construction of taller buildings nearby, but not on the site owned by Parkview Associates.

During that time period, changes in the boundaries of SSA authority as well as the rights of disability applicants and recipients generating changing standards of evaluation during the application and appeals process.

We did not observe similar changes in the boundaries or areas of representations of body parts other than neck even when movements at suprathreshold currents were noted.

After changes in the boundary conditions, succession and migration had a strong influence.

Variations in mode shapes caused by the changes in the boundary conditions are also presented.

Experimental studies for the water/acetone/cellulose acetate system demonstrate that changes in the boundary conditions can result in dramatically different membrane morphologies.

Any feature in the problem definition that would lead to local singularities, such as sharp corners or abrupt changes in the boundary conditions, renders these methods less effective.

Additional analysis challenges are attributed to changes in the boundary conditions of SU-FREI as a result of rollover type deformation.

We suggest the resulting numerical steady state solution may be viewed as a solution to a "nearby" boundary value problem with high sensitivity to changes in the boundary conditions.

In practice, damage identification problems can occur due to minor changes in the boundary conditions of the test set-up especially if classic input output vibration measurements are required for the diagnosis of a lightweight structure.

In many engineering problems, boundaries with sharp corners or abrupt changes in the boundary conditions and/or the material properties give rise to singularities of various types which tend to slow down the rate of convergence with respect to decreasing the mesh size of any standard numerical method used for obtaining the solution.